Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 114 of 259
+CGEQMIN – 3G Quality Of Service Profile (Minimum Acceptable)
+CGEQMIN: "IPV6",(0-4),(0-512),(0-16000),(0-512),(0-
16000),(0-2),(0-
1520),("0E0","1E1","1E2","7E3","1E3","1E4","1E5","1E6"),("
0E0","5E2","1E2","5E3","4E3","1E3","1E4","1E5","1E6","6E8"
),(0-3),(0,100-4000),(0-3)
OK
Reference 3GPP TS 27.007; 3GPP TS 03.60/23.060; 3GPP TS 24.008
3.5.4.7.7 Quality Of Service Profile (Requested) - +CGQREQ
+CGQREQ - Quality Of Service Profile (Requested)
AT+CGQREQ=
[<cid>
[,<precedence>
[,<delay>
[,<reliability>
[,<peak>
[,<mean>]]]]]]
Set command allows to specify a Quality of Service Profile that is used
when the terminal sends an Activate PDP Context Request message to the
network. It specifies a profile for the context identified by the (local) context
identification parameter, <cid>.
Parameters:
<cid> - PDP context identification (see +CGDCONT command).
<precedence> - precedence class
<delay> - delay class
<reliability> - reliability class
<peak> - peak throughput class
<mean> - mean throughput class
If a value is omitted for a particular class then this class is not checked.
Note: a special form of the Set command, +CGQREQ=<cid> causes the
requested profile for context number <cid> to become undefined.
AT+CGQREQ? Read command returns the current settings for each defined context in the
format:
+CGQREQ: <cid>,<precedence>,<delay>,<reliability>,<peak>,
<mean>[<CR><LF>+CGQREQ: <cid>,<precedence>,
<delay>,<reliability>,<peak>,<mean>[…]]
If no PDP context has been defined, it has no effect and OK result code is
returned.
AT+CGQREQ=? Test command returns as a compound value the type of the current PDP
context and the supported values for the subparameters in the format:
+CGQREQ: <PDP_Type>,(list of supported <precedence>s),
(list of supported <delay>s),(list of supported <reliability>s),
(list of supported <peak>s),(list of supported <mean>s)
Note: only the “IP” PDP_Type is currently supported.
Example
AT+CGQREQ?