Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 110 of 259
+CGDCONT - Define PDP Context
OK
AT+CGDCONT=?
+CGDCONT: (1-16),"IP",,,(0-2),(0-4)
+CGDCONT: (1-16),"PPP",,,(0-2),(0-4)
+CGDCONT: (1-16),"IPV6",,,(0-2),(0-4)
OK
Reference 3GPP TS 27.007
3.5.4.7.5 Quality Of Service Profile (Minimum Acceptable) - +CGQMIN
+CGQMIN - Quality Of Service Profile (Minimum Acceptable)
AT+CGQMIN=
[<cid>
[,<precedence>
[,<delay>
[,<reliability>
[,<peak>
[,<mean>]]]]]]
Set command allows to specify a minimum acceptable profile which is
checked by the terminal against the negotiated profile returned in the
Activate PDP Context Accept message.
Parameters:
<cid> - PDP context identification (see +CGDCONT command).
<precedence> - precedence class
<delay> - delay class
<reliability> - reliability class
<peak> - peak throughput class
<mean> - mean throughput class
If a value is omitted for a particular class then this class is not checked.
Note: a special form of the Set command, +CGQMIN=<cid> causes the
requested profile for context number <cid> to become undefined.
AT+CGQMIN? Read command returns the current settings for each defined context in the
format:
+CGQMIN: <cid>,<precedence>,<delay>,<reliability>,<peak>,
<mean>[<CR><LF>+CGQMIN: <cid>,<precedence>,
<delay>,<reliability>,<peak>,<mean>[…]]
If no PDP context has been defined, it has no effect and OK result code is
returned.
AT+CGQMIN=? Test command returns as a compound value the type of the current PDP
context and the supported values for the subparameters in the format:
+CGQMIN: <PDP_Type>,(list of supported <precedence>s),
(list of supported <delay>s),(list of supported <reliability>s),
(list of supported <peak>s),(list of supported <mean>s)