Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 97 of 228
+CGQREQ - Quality Of Service Profile (Requested)
<delay>,<reliability>,<peak>,<mean>[…]]
If no PDP context has been defined, it has no effect and OK result code is returned.
AT+CGQREQ=?
Test command returns as a compound value the type of the current PDP context and
the supported values for the subparameters in the format:
+CGQREQ: <PDP_Type>,(list of supported <precedence>s),
(list of supported <delay>s),(list of supported <reliability>s),
(list of supported <peak>s),(list of supported <mean>s)
Note: only the “IP” PDP_Type is currently supported.
Example
AT+CGQREQ?
+CGQREQ: 1,0,0,3,0,0
OK
AT+CGQREQ=1,0,0,3,0,0
OK
AT+CGQREQ=?
+CGQREQ: "IP",(0-3),(0-4),(0-5),(0-9),(0-18,31)
+CGQREQ: "PPP",(0-3),(0-4),(0-5),(0-9),(0-18,31)
+CGQREQ: "IPV6",(0-3),(0-4),(0-5),(0-9),(0-18,31)
OK
Reference 3GPP TS 27.007; 3GPP TS 03.60/23.060
3.5.3.7.9. 3G Quality Of Service Profile (Requested) - +CGEQREQ
+CGEQREQ – 3G Quality Of Service Profile (Requested)
AT+CGEQREQ=
[<cid>
[,<Traffic class>
[,<Maximum
bitrate UL>
[,<Maximum
bitrate DL>
[,<Guaranteed
bitrate UL>
[,<Guaranteed
bitrate DL>
[,<Delivery order>
[,<Maximum SDU
size>
[,<SDU error
ratio>
[,<Residual bit
error ratio>
Set command allows to specify a 3G quality of service profile for the context
identified by the(local) context identification parameter <cid> which is used when the
MT sends an Activate PDP Context Request message to the network.
Parameters:
<cid> - PDP context identification (see +CGDCONT command).
<Traffic class> - Traffic class
0 - conversational
1 - streaming
2 - interactive
3 - background
4 - subscribed value
<Maximum bitrate UL> - Maximum bitrate Up Link (kbits/s)
0 - subscribed value
1~63 - in 1 kbps steps
64~568 - in 8 kbps steps
576~8640 - in 64 kbps steps