Specifications

HE863 family AT commands reference guide

80377ST10083a Rev.4 – 2012-02-01

3.5.3.4. Mobile Equipment Control

3.5.3.4.1. Phone Activity Status - +CPAS

+CPAS - Phone Activity Status

AT+CPAS

Execution command reports the device status in the form:

+CPAS: <pas>

Where:

<pas> - phone activity status

0 - ready (device allows commands from TA/TE)

1 - unavailable (device does not allow commands from TA/TE)

2 - unknown (device is not guaranteed to respond to instructions)

3 - ringing (device is ready for commands from TA/TE, but the ringer is active)

4 - call in progress (device is ready for commands from TA/TE, but a call is in

progress)

5 - asleep (MT is unable to process commands from TA/TE because it is in a low

functionality state)

AT+CPAS=?

Test command reports the supported range of values for <pas>.

Note: although +CPAS is an execution command, 3gpp TS 27.007 requires the Test

command to be defined.

Example

ATD03282131321;

AT+CPAS

+CPAS: 4 the called phone has answered to your call

ATH

Reference 3GPP TS 27.007

3.5.3.4.2. Set Phone Functionality - +CFUN

+CFUN - Set Phone Functionality

AT+CFUN=

[<fun>[,<rst>]]

Set command selects the level of functionality in the ME.

Parameters:

<fun> - is the power saving function mode

0 - powerdown module.

1 - mobile full functionality with power saving disabled (factory default)

4 - disable both TX and RX

5 - mobile full functionality with power saving

<rst> - reset flag

0 - do not reset the ME before setting it to <fun> functionality level

Note: For AT&T model, mode 0 and 4 have same action which is disabling both