Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 60 of 228
+CCFC - Call Forwarding Number And Condition
AT+CCFC=
<reason>,
<cmd>[,<number>[,<
type>[,<class>
[,,,<time>]]]
Execution command controls the call forwarding supplementary service.
Registration, erasure, activation, deactivation, and status query are supported.
Parameters:
<reason>
0 - unconditional
1 - mobile busy
2 - no reply
3 - not reachable
4 - all calls
5 - all conditional calls
<cmd>
0 - disable
1 - enable
2 - query status
3 - registration
4 - erasure
<number> - string type phone number of forwarding address in format specified
by <type> parameter
<type> - type of address octet in integer format :
129 - national numbering scheme
145 - international numbering scheme (contains the character "+")
<class> - sum of integers each representing a class of information which the
command refers to; default 7 (voice + data + fax)
1 - voice (telephony)
2 - data
4 - fax (facsimile services)
8 - short message service
16 - data circuit sync
32 - data circuit async
64 - dedicated packet access
128 - dedicated PAD access
<time> - time in seconds to wait before call is forwarded; it is valid only when
<reason> "no reply" is enabled (<cmd>=1) or queried (<cmd>=2)
1..30 - automatically rounded to a multiple of 5 seconds (default is 20)
Note: when <cmd>=2 and command successful, it returns:
+CCFC: <status>,<class1>[,<number>,<type>[,,,<time>]][<CR><LF>
+CCFC: <status>,<class2>[,<number>,<type>[,,,<time>]][ … ]]
where:
<status> - current status of the network service
0 - not active