Specifications

HE863 family AT commands reference guide

80377ST10083a Rev.4 – 2012-02-01

+CLIR - Calling Line Identification Restriction

1 - CLIR facility active (CLI not sent)

2 - CLIR facility not active (CLI sent)

<m> - facility status on the Network

0 - CLIR service not provisioned

1 - CLIR service provisioned permanently

2 - unknown (e.g. no network present, etc.)

3 - CLI temporary mode presentation restricted

4 - CLI temporary mode presentation allowed

AT+CLIR=?

Test command reports the supported values of parameter <n>.

Reference 3GPP TS 27.007

Note This command sets the default behaviour of the device in outgoing calls.

3.5.3.3.9. Connected line identification presentation - +COLP

+COLP - Connected line identification presentation

AT+COLP=[<n>]

Set command enables or disables the presentation of the COL at the TE

Parameter:

<n>

0 – disable (factory default)

1 - enable

Note: When enabled (and called subscriber allows),

+COLP: <number>,<type>[,<subaddr>,<satype> [,<alpha>]] intermediate result

code is returned from TA to TE before any +CR or V.25ter [14] responses. It is

manufacturer specific if this response is used when normal voice call is established.

AT+COLP?

Read command gives the status of <n>, and also triggers an interrogation of the

provision status of the COLP service according 3GPP TS 22.081 [3] (given in

<m>).

+COLP: <n>,<m>

Where,

<n>

0 – disable

1 – enable

<m>

0 - COLP not provisioned

1 - COLP provisioned

2 - unknown (e.g. no network, etc.)

AT+COLP=?

Test command returns supported parameters <n>

Reference 3GPP TS 27.007

3.5.3.3.10. Call Forwarding Number And Conditions - +CCFC

+CCFC - Call Forwarding Number And Condition