Specifications

HE863 family AT commands reference guide

80377ST10083a Rev.4 – 2012-02-01

+CPWD - Change Facility Password

Parameters:

<fac> - “P2” and other values as defined for

+CLCK

<oldpwd> - string type, it shall be the same as password specified for the facility

from the ME user interface or with command +CPWD.

<newpwd> - string type, it is the new password

Note: parameter <oldpwd> is the old password while <newpwd> is the new one.

AT+CPWD=?

Test command returns a list of pairs (<fac>,<pwdlength>) which presents the

available facilities and the maximum length of their password (<pwdlength>)

Example

at+cpwd=?

+CPWD: (“SC”,8”),(“P2”,8),(“AO”,4),(“OI”,4),(“OX”,4),(“AI”,4),(“IR”,4),

(“AB”,4),(“AG”,4),(“AC”,4)

Reference 3GPP TS 27.007

3.5.3.3.7. Calling Line Identification Presentation - +CLIP

+CLIP - Calling Line Identification Presentation

AT+CLIP=[<n>]

Set command enables/disables the presentation of the CLI (Calling Line Identity) at

the TE. This command refers to the UMTS supplementary service CLIP (Calling

Line Identification Presentation) that enables a called subscriber to get the CLI of

the calling party when receiving a mobile terminated call.

Parameters:

<n>

0 - disables CLI indication (factory default)

1 - enables CLI indication

If enabled the device reports after each RING the response:

+CLIP: <number>,<type>,””,128,<alpha>,<CLI_validity>

where:

<number> - string type phone number of format specified by <type>

<type> - type of address octet in integer format

128 - both the type of number and the numbering plan are unknown

129 - unknown type of number and ISDN/Telephony numbering plan

145 - international type of number and ISDN/Telephony numbering plan (contains

the character "+")

<alpha> - string type; alphanumeric representation of <number> corresponding to

the entry found in phonebook; used character set should be the one

selected with command Select TE character set +CSCS.

<CLI_validity>