Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 50 of 228
+CR - Service Reporting Control
+CR: <mode>
AT+CR=?
Test command returns the supported range of values of parameter <mode>.
Reference 3GPP TS 27.007
3.5.3.2.6. Extended Error Report - +CEER
+CEER - Extended Error Report
AT+CEER
Execution command returns one or more lines of information text <report>
offering the TA user an extended error report, in the format:
+CEER: <report>
This report regards some error condition that may occur:
- the failure in the last unsuccessful call setup (originating or answering)
- the last call release
- the last unsuccessful GPRS attach or unsuccessful PDP context activation,
- the last GPRS detach or PDP context deactivation.
Note: if none of this condition has occurred since power up then “Normal,
unspecified” condition is reported
AT+CEER=?
Test command returns OK result code.
Reference 3GPP TS 27.007
3.5.3.2.7. Cellular Result Codes - +CRC
+CRC - Cellular Result Codes
AT+CRC=
[<mode>]
Set command controls whether or not the extended format of incoming call
indication is used.
Parameter:
<mode>
0 - disables extended format reporting (factory default)
1 - enables extended format reporting:
When enabled, an incoming call is indicated to the TE with unsolicited result code
+CRING: <type>
instead of the normal RING.
where
<type> - call type:
ASYNC - asynchronous transparent data
SYNC - synchronous transparent data
REL ASYNC - asynchronous non-transparent data
REL SYNC - synchronous non-transparent data
FAX - facsimile (TS 62)