Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 196 of
228
#SKTD - Socket Dial
AT#SKTD=1,1024,"123.255.020.001", ,1025
CONNECT
In this way my local port 1025 is opened to the remote port 1024
AT#SKTD=0,1024,"www.telit.net", 255
CONNECT
Note The main difference between this command and #SKTOP is that this command
does not interact with the GPRS context status, leaving it ON or OFF according to
the #GPRS setting, therefore when the connection made with #SKTD is closed the
context (and hence the local IP address) is maintained.
3.5.5.1.76. Socket Listen - #SKTL
#SKTL - Socket Listen
AT#SKTL
=[<mode>,
<socket type>,
<input port>,
[<closure type>]]
Execution command opens/closes the socket listening for connection requests.
Parameters:
<mode> - socket mode
0 - closes socket listening
1 - starts socket listening
<socket type> - socket protocol type
0 - TCP
<input port> - local host input port to be listened
0..65535 - port number
<closure type> - socket closure behaviour for TCP
0 - local host closes immediately when remote host has closed (default)
255 - local host closes after an escape sequence (+++)
Command returns the OK result code if successful.
Note: the command to be successful requests that:
- the GPRS context 1 is correctly set with +CGDCONT
- the authentication parameters are set (#USERID, #PASSW)
- the GPRS coverage is enough to permit a connection
- the GPRS has been activated with AT#GPRS=1
When a connection request comes on the input port, if the sender is not filtered by
the internal firewall (see command #FRWL), an unsolicited code is reported:
+CONN FROM: <remote addr>
Where:
<remote addr> - host address of the remote machine that contacted the device.
When the connection is established the CONNECT indication is given and the
modem goes into data transfer mode.