Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 185 of
228
#E2SMSRI - SMS Ring Indicator
incoming SM, in the format:
#E2SMSRI: <n>
Note: as seen before, the value <n>=0 means that the RI pin response to an
incoming SM is disabled.
AT#E2SMSRI=?
Reports the range of supported values for parameter <n>
Example AT#E2SMSRI=50
OK
3.5.5.1.60. Message Waiting Indication - #MWI
#MWI - Message Waiting Indication
AT#MWI=<enable>
Set command enables/disables the presentation of the message waiting indicator
URC.
Parameter:
<enable>
0 - disable the presentation of the #MWI URC
1 - enable the presentation of the #MWI URC each time a new message waiting
indicator is received from the network and, at startup, the presentation of the
status of the message waiting indicators, as they are currently stored on SIM..
The URC format is:
#MWI: <status>,<indicator>[,<count>]
where:
<status>
0 - clear: it has been deleted one of the messages related to the indicator
<indicator>.
1 - set: there’s a new waiting message related to the indicator <indicator>
<indicator>
1 - either Line 1 (CPHS context) or Voice (3GPP context)
2 - Line 2 (CPHS context only)
3 - Fax
4 - E-mail
5 - Other
<count> - message counter: network information reporting the number of pending
messages related to the message waiting indicator <indicator>.
The presentation at startup of the message waiting indicators status, as they are
currently stored on SIM, is as follows:
#MWI: <status>[,<indicator>[,<count>][<CR><LF>
#MWI: <status>,<indicator>[,<count>][...]]]