Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 184 of
228
+XSIMSTATE - Display SIM and Phonelock Status
<Lock state>
parameter shows the state of the lock for <fac>
0 the lock is ARMED
1 the lock is ACTIVE
2 the lock is PERMANENT_ACTIVE
3 the lock is BLOCKED
4 the lock is DEACTIVE
5 the lock is DISABLED
6 the lock has just been AUTOACTIVATED
<Lock result>
parameter shows the result of the lock verification for <fac>
0 continue operation
1 verification needed
2 no further operation possible
3 lock error
4 unknown
Note 2:
+XSIM notifications are designed to give only the initial state of the SIM/SIM-
PIN at the startup(based on SI_INFO_IND) or on restart. Update indications
resulting +XSIM: 3 (or 4 or 5) is not given after SIM-PIN verification, AP shall
rely on AT+CPIN responses for this. Apart from this, “+XSIM: 7” indication is
given to indicate the completion of (U)SIMAP initializations (based on
SI_INIT_IND).
AT+XSIMSTATE?
Read command returns the status of the mode selected.
+XSIMSTATE: <mode>
AT+XSIMSTATE=?
Test command returns the list of supported<mode>s.
+XSIMSTATE: (0,1)
3.5.5.1.59. SMS Ring Indicator - #E2SMSRI
#E2SMSRI - SMS Ring Indicator
AT#E2SMSRI=
[<n>]
Set command enables/disables the Ring Indicator pin response to an
incoming SMS message. If enabled, a negative going pulse is generated on
receipt of an incoming SMS message. The duration of this pulse is
determined by the value of <n>.
Parameter:
<n> - RI enabling
0 - disables RI pin response for incoming SMS messages (factory default)
50..1150 - enables RI pin response for incoming SMS messages. The value of <n>
is the duration in ms of the pulse generated on receipt of an incoming SM.
AT#E2SMSRI?
Read command reports the duration in ms of the pulse generated on receipt of an