Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 181 of
228
#DBGS – Debug screen command
changes
<ir_hocc_3g_2g_cnt_at> - number of attempted UMTS to GSM HO or cell
changes
<ho_3g_3g_cnt_su> - number of successful INTRA UAS handovers
<ho_3g_3g_cnt_su> - number of attempted INTRA UAS handovers
<ciphering> - ciphering dis-/enabled (0/1) (can only be changed via Phonetool)
<integr_prot> - integrity protection dis-/enabled (0/1) (can only be changed via
Phonetool)
AT#DBGS? #DBGS: <mode>,<page_nr>
where:
<mode> - see before
<page_nr> - see before
AT#DBGS=?
Test command returns all supported values of the parameter.
3.5.5.1.55. Display PIN Counter - #PCNT
#PCNT - Display PIN Counter
AT#PCNT
Execution command reports the PIN/PUK or PIN2/PUK2 input remaining attempts,
depending on +CPIN requested password in the format:
#PCNT:
<PIN attempts>, <PIN2 attempts>, <PUK attempts>, <PUK2 attempts>
where:
<PIN attempts> - PIN1 remaining attempts
<PIN2 attempts> - PIN2 remaining attempts
<PUK attempts> - PUK1 remaining attempts
<PUK2 attempts> - PUK2 remaining attempts
0 - the SIM is blocked.
1..3 - if the device is waiting either SIM PIN or SIM PIN2 to be given.
1..10 - if the device is waiting either SIM PUK or SIM PUK2 to be given.
AT#PCNT=?
Test command returns the OK result code.
3.5.5.1.56. Query SIM Status - #QSS
#QSS - Query SIM Status
AT#QSS=
<mode>
Set command enables/disables the Query SIM Status unsolicited indication in the
ME.
Parameter:
<mode> - type of notification
0 - disabled (factory default); it’s possible only to query the current SIM status
through Read command AT#QSS?
1 - enabled; the ME informs at every SIM status change through the following
unsolicited indication: