Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 179 of
228
#DBGS – Debug screen command
<ecn0> - ECN0 (dB - positive value presented positive) of cell
<dsc> - Downlink Signaling Counter
<rll> - Radio Link Loss Counter
<ul_meas_cnt> - Number of measurements sent during the last reporting period
<oos_cnt> - Number of times UE went out of service
<tx_pwr> - Tx output power
<ch_type> - Channel type of the current connection as follows (10.5.2.5
GSM04.08), (range 0x00 - 0xFF, 0xFF means invalid value):
00 - INVALID_CHN_TYPE
01 - TCH_F
02 - TCH_H
03 - SDCCH_4
04 - SDCCH_8
05 - TCH_H_H
06 - TCH_F_M
<ch_mode> - Channel mode of current connection (10.5.2.6 GSM04.08), (range
0x00 - 0xFF, 0xFF means invalid value) mapped to an internal value:
00 - MODE_SIG_ONLY
01 - MODE_SPEECH_F
02 - MODE_SPEECH_H
03 - MODE_DATA_96_F
04 - MODE_DATA_48_F
05 - MODE_DATA_48_H
06 - MODE_DATA_24_F
07 - MODE_DATA_24_H
08 - MODE_SPEECH_F_V2
09 - MODE_SPEECH_F_V3
0A - MODE_SPEECH_H_V2
0B - MODE_SPEECH_H_V3
0C - MODE_DATA_144_F
<rx_power_level> - signal strength dBm (negative values)
<SIM_phase>
0 - 3G
2 - 2G
<2G_PB_supp>
0 - supported
1 - not supported