Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 174 of
228
#DBGS – Debug screen command
1-8 number of response page (see response syntax description above), where 1 is
used if this parameter is not stated
Response syntax for page_nr 1
#DBGS:
RAT:<rat>,
MCC:<mobile_country_code>, MNC:<mobile_network_code>,
MMs: <mm_state>, LUS: <location_update_status>, LAC: <LAC>, MMSs:
<mm_service_state>, T: <active_timer_bitmap>, B: <band>,
Only if RAT:”GSM”
RR: <rr_state>, Arfcn: <arfcn>, Arfcn_ded: <arfcn_ded>, Bsic: <bsic>, Rssi:
<rssi>,
C1: <c1>, RxQualFull: <RxQualFull>, txpwr:<txpwr>, rx_power_level:
<rx_power_level>,
amr_codec_set:<amr_codec_set>,
amr_cod_ul :<amr_cod_ul>,amr_cod_dl:<amr_cod_dl>
Only if RAT:”UMTS”
URR: <rrc_state>, DLF: <dl_frequency>, PSC:<scrambling_code>,
RSCP:<rscp>, ECN0: <ecn0>, rx_power_level: <rx_power_level>
DRX_cycle : <drx_cycle>
CallConnect : <call_connect>
Response syntax for page_nr 2:
#DBGS:
RAT:<rat>,
MCC:<mobile_country_code>, MNC:<mobile_network_code>,
Only if RAT:”GSM”
RSR: <reselection_reason>,RC:<release_cause>, ch_type:<ch_type>,
ch_mode:<ch_mode>, ndsc:<dsc>,
rll:<rll>, t3212:<t3212>,
Only if RAT:”GSM”
RxLevFull:<RxLevFull>,RxLevSub:<RxLevSub>,RxQualFull:<RxQualFull>,
RxQualSub:<RxQualSub>,
Only if RAT:”GSM”
rx_acc_min: <rx_acc_min>, C1: <c1>, C2: <c2>, txpwr:<txpwr>,
dtx_used:<dtx_used>
Only if RAT:”UMTS”
URR: <rrc_state>, PSM: <power_saving_mode>, D:<ps_data_transfered>,
RC:<release_cause>,