Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 173 of
228
#CELLINFO – Provide Cell information
<mode>
0 - disable the periodic reporting
1 - enable the reporting
2 - currently not used (backward compatibility)
For GSM cells:
URC: #CELLINFO:
<type>,<MCC>,<MNC>,<LAC>,<CI>,<RxLev>[,<t_advance>]
For UMTS cells:
URC: #CELLINFO:
<type>,<MCC>,<MNC>,<LAC>,<CI>,<scrambling_code>,
<dl_frequency>,<rscp>,<ecn0>
where:
<type>
0 - GSM serving cell
1 - GSM neighbour cell
2 - UMTS serving cell
3 - UMTS neighbour cell
4 - UMTS detected cell
<MCC>,<MNC>,<LAC>,<CI>,<scrambling_code>,<rscp>,<ecn0>,<dl_freque
ncy> - see #CGED
<RxLev> - signal strength
<t_advance> - only valid for the serving cell
AT#CELLINFO? #CELLINFO: <mode>,<type>,<MCC>,
<MNC>,<LAC>,<CI>,<RxLev> [,<t_advance>]
#CELLINFO: <mode>,<type>,<MCC>,
<MNC>,<LAC>,<CI>,<scrambling_code>,<dl_frequency>,<rscp>,
<ecn0>
AT#CELLINFO=?
Test command returns the range of supported <mode>s.
3.5.5.1.54. Debug screen command - #DBGS
#DBGS – Debug screen command
AT#DBGS=
<mode>[,<page_nr>]
This command returns a dump of the cell environment, either as a one shot dump or
as a periodic refreshed dump (each 5 seconds), dependent on the command
parameter <mode>. The displayed parameters are dependent on the fact whether the
UMTS is supported (Note: define UMTS_SUPPORT exists) and if it is, dependent
on the currently supported RAT (GSM, UMTS).
Parameter:
<mode>
0 - one shot dump
1 - periodic refreshed dump (is not allowed for page_nr=6)
2 - stop periodic dump (is not allowed for page_nr=6)
<page_nr>