Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 172 of
228
#CGED – GPRS cell environment description
NB_MCS_8
NB_MCS_9
NB_MCS_5_7
NB_MCS_6_9
AB_8
AB_11
AB_11_E
UMTS/GSM MM PARAMETERS:
<mm_state> - integer, range 0-99
<mm_service_state> - integer, range 0-99
<ms_class> - the MS GPRS-class (previously stored in ATC either at reception of
message MN_GCLASS_IND or sending the message MN_GCLASS_REQ); it may
be:
class A
class B
class CG: class C in GPRS only mode
classCC: class C in circuit switched only mode (lowest class)
<active_timer_bitmap> - four hex coded digits
<location_update_status> - integer, range 0-9
<limited_service> - may be 0-1
<gprs_supported> - may be 0-1
<ready_state> - may be 0-1
<cell_reselecetion_total> - integer, range 0-999
<ir_cell_reseelection_counter> - integer, range 0-999
<attempted_ir_cell_reselection> - integer, range 0-999
<ir_handover> - integer, range 0-999
<attempted_ir_handover> - integer, range 0-999
<mobile_country_code> - MCC three hexcoded digits, range 0-999
<mobile_network_code> - MNC two hexcoded digits, range 0-99
<location_area_code> - LAC, two octets, range 0-65535
<routing_area_code> - integer, range 0-255
<access technology> - integer, range 0..8,
GSM=0, GPRS=1, EGPRS=2, EGPRS_PCR=3, EGPRS_EPCR=4, UMTS=5
(unused), DTM=6, EGPRS_DTM=7, undefined=8
AT#CGED?
Read command reports the current value of the parameter.
AT#CGED=?
Test command returns all supported values of the parameter.
3.5.5.1.53. Provide Cell information - #CELLINFO
#CELLINFO – Provide Cell information
AT#CELLINFO=<m
ode>
This command provides a periodic reporting of the serving cell and the neighbour
cells.
Parameter: