Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 170 of
228
#CGED – GPRS cell environment description
<rrc_state> - may be "CD", "CF", "CP", "UP", "ID", "ST"- standing for
CELL_DCH (0), CELL_FACH(1), CELL_PCH(2), URA_PCH(3), IDLE(4),
START(5)
<urrcdc_state> - indicated by three hex digits, (octet1,2:event, 3:state)
<urrcbp_state> - indicated by four hex digits, (1,2:event, 3,4:state)
<urrcm_state> - indicated by three hex digits (1:event, 2:state, 3:nr of sent
measurements)
<as_error_code> - indication about error in UAS; integer, range 0-99
<release_cause> - integer, range 0-99
<out_of_service> - may be 0-1
<meas_bler> - block error rate, range 1.0 *10exp(-6) … 9.9*10exp(-1); the value -
is indicated if the parameter is not available or for all cells except DCH; the internal
received value is divided by 2^23 before display;
<target_sir> - target SIR, range -10 … +20 (3 digits are always displayed); the
value ‘-‘ is displayed if the parameter is not available or for all cells except DCH;
the internal received value is divided by 2^24 before display;
<meas_sir> - integer displayed in hexadecimal format, range -10 … +20; the
value ’-‘ is displayed if the parameter is not available or for all cells except DCH;
the internal received value is divided by 2^24 before display;
<hierarchical_cell_structure> - may be 0-1
<high_mobility_detected> - may be 0-1
<limited_mode> - may be 0-1
<cell_identity> - indicated by seven hex digits
<dl_frequency> - integer, range 0-16383
<ul_frequency> - integer, range 0-16383
<ciphering> - the GSM Ciphering may be ON or OFF
<gprs_ciphering> - It is the GPRS Ciphering Algorithm GEA1 - GEA7
<ps_data_transfered> - may be 0-1
<power_saving_mode> - may be 0-1
<cell_type>
"AS" - Active Set,
"VAS"- Virtual Active Set
"M", - Monitored Cells
"D", - Detected Cells
"G", - GSM cells
"U", - UMTS cells
"NU",- Non Ranked UMTS cells
"NG" - Non Ranked GSM cells
<scrambling_code> - integer, range 0-511
<rscp> - Received Signal Code Power, range 0-91
<ecno> - energy per chip/noice, range 0-24
<gsm_band>
"D",- 1800 MHz
"P",- 1900 MHz
"G" - 900 MHz