Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 156 of
228
#NITZ - Network Timezone
2 - enables Full Network Name applying
4 - it sets the #NITZ URC ‘extended’ format (see <datetime> below)
8 – it sets the #NITZ URC ‘extended’ format with Daylight Saving Time
(DST) support (see <datetime> below).
<mode>
0 - disables #NITZ URC (factory default)
1 - enables #NITZ URC; after date and time updating the following
unsolicited indication is sent:
#NITZ: <datetime>
where:
<datetime> - string whose format depends on subparameter <val>
“yy/MM/dd,hh:mm:ss” - ‘basic’ format, if <val> is in (0..3)
“yy/MM/dd,hh:mm:ss±zz” - ‘extended’ format, if <val> is in (4..7)
“yy“yy/MM/dd,hh:mm:ss±zz,d” - ‘extended’ format with DST support, if
<val> is in (8..15)
where:
yy - year
MM - month (in digits)
dd - day
hh - hour
mm - minute
ss - second
zz - time zone (indicates the difference, expressed in quarter of an
hour, between the local time and GMT; two last digits are
mandatory, range is -47..+48)
d – number of hours added to the local TZ because of Daylight Saving Time
(summertime) adjustment; range is 0-2.
Note: If the DST information isn’t sent by the network, then the <datetime>
parameter has the format “yy/MM/dd,hh:mm:ss±zz”
AT#NITZ?
Read command reports whether (a) automatic date/time updating, (b) Full
Network Name applying, (c) #NITZ URC (as well as its format) are currently
enabled or not, in the format:
#NITZ: <val>,<mode>
AT#NITZ=?
Test command returns supported values of parameters <val> and <mode>.
3.5.5.1.41. Select Band - #BND
#BND - Select Band
AT#BND=
<GSM band>,
Set command selects the current band.
This command allows switching from automatic band selection to selection of