Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 144 of
228
#RFSTS – Read current network Status
nEc/Io Ec/Io of n th active Set
Note 1 : nAST : Number of active set. Maximum is 6
Note 2 : If <nAST> is 1, it means that number of active set is 1. In this case, the module
does not display parameters <nUARFCN>,<nPSC> and <nEc/Io>.
3.5.5.1.15. Serving Cell Information - #SERVINFO
#SERVINFO - Serving Cell Information
AT#SERVINFO
Execution command reports information about serving cell, in the format:
(GSM network)
#SERVINFO: <B-ARFCN>,<dBM>,<NetNameAsc>,<NetCode>,
,<BSIC>,<LAC>,<TA>,<GPRS>[,[<PB-ARFCN>],[<NOM>],
<RAC>,[PAT]]
where:
<B-ARFCN> - BCCH ARFCN of the serving cell
<dBM> - received signal strength in dBm
<NetNameAsc> - operator name, quoted string type
<NetCode> - country code and operator code, hexadecimal representation
<BSIC> - Base Station Identification Code
<LAC> - Localization Area Code
<TA> - Time Advance: it’s available only if a GSM or GPRS is running
<GPRS> - GPRS supported in the cell
0 - not supported
1 - supported
The following information will be present only if GPRS is supported in the cell
<PB-ARFCN> - PBCCH ARFCN of the serving cell; it’ll be printed only if
PBCCH is supported by the cell, otherwise the label “hopping” will be
printed
<NOM> - Network Operation Mode
..”I”
“II”
..”III”
<RAC> - Routing Area Color Code
<PAT> - Priority Access Threshold
..0
..3..6
(WCDMA network)
#SERVINFO: <UARFCN>, <dBM>, <NetNameAsc>,<NetCode>,
<PSC>,<LAC>,<DRX>,<SD>,<RSCP>, <NOM>,<RAC>
where: