User Manual

12
HIGH EFFICIENT 3-SPEED IMPACT WRENCH
HIGH EFFICIENT 3-SPEED IMPACT DRIVER
ENG
TECHNICAL DATA
RK2855K2 RK2868K2
Charger voltage 120V~60Hz
Rated voltage 20 V
Max*
No-load speed 0-1300/2100/2900/min
Impact rate 0-1600/2900/3300 IPM
Max torque
885/1590/2600
in.lbs
530/930/1550
in.lbs
Chuck size
1/2 inch (13 mm)
square
1/4 inch (6.35 mm)
hex
Machine weight 3.17 lbs
* Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
ASSEMBLY AND OPERATION
ACTION FIGURE
Before operation
Checking the battery charge condiction See Fig. A1
Removing the Battery See Fig. A2
Charging the Battery See Fig. A3
Installing the Battery See Fig. A4
Assembly
Inserting and removing Bits and Socket
See Fig. B1,
B2, B3, B4
Assembling the Belt Hook and Bit Clip
See Fig. C1,
C2, C3, C4
Operaton
S witch Lock See Fig. D1
Forward And Reverse Rotation
Control
Warning: Never Change The
Direction Of Rotation When The
Chuck Is Rotating, Wait Until It Has
Stopped!
See Fig. D2,
D3
Variable Speed Control See Fig. E
Operating the On/Off Switch and
activating Light
Warning: Do not operate for
long periods at low speed because
excess heat will be produced
internally.
See Fig. F
Using The Sight Light
Before operation, the Sight Light will
be activated when the On/Off switch is
slightly depressed, and will automatically
turn off 20 seconds after the On/Off
switch is released.
The tool and battery are equipped with a
protection system to extend battery life.
The Sight Light will flash a warning for
3 seconds, then the tool will stop. The
automatic protection system stops the
tool during the following conditions:
• Overloaded: The tool is operated in
a manner that causes it to draw an
abnormally high current. In this situation,
release the Switch and stop the
application that caused the overload. Pull
the Switch again to restart.
• Overheated: Under the condition above,
if the tool does not start, the Tool and
Battery are overheated. Let the Tool and
Battery cool before pulling the Switch
again.
• Low battery voltage: The remaining
Battery capacity is too low and the tool
will not operate. Remove and recharge
the Battery.
Warning: To turn on the Light, press
the On/Off switch and make sure the
Forward/Reverse Rotation Control is on
right/left position.
See Fig. F
TROUBLESHOOTING
1. I CAN NOT FIT THE BATTERY INTO THE BATTERY
CHARGER. WHY?
The battery can be inserted into the charger only in one
direction. Turn the battery around until it can be inserted
into the slot, the red LED Light should turn on when the
battery is charging.