Switch User Manual
Table Of Contents
- 1783-UM002C-EN-E, Stratix 8000 Ethernet Managed Switches Hardware User Manual
- Preface
- Table of Contents
- 1 - Start
- 2 - Install the Switch
- Installation Guidelines
- Before You Begin
- Verify Package Contents
- Add Modules to the Switch
- Install the Switch
- Install or Remove the CompactFlash Card
- Set Up the Switch Initially with Express Setup
- Configure and Manage the Switch
- Reset the Switch to Factory Defaults
- Connect to the Switch Ports
- Verify Port Connectivity
- Verify Switch Operation
- Connect a Computer or a Terminal to the Console Port
- Run a Power-on Self-test (POST)
- Verify POST Results
- Disconnect Power
- Install and Remove SFP Modules
- Connect to SFP Modules
- 3 - Troubleshoot the Switch
- 4 - Cable and Connectors
- Index
- Back Cover
78 Publication 1783-UM002C-EN-P - April 2009
Chapter 4
100BASE-FX Ports
The 100BASE-FX ports use the following:
• LC connectors, as shown in the following figure.
• 50/125- or 62.5/125-micron multimode fiber-optic cables
Fiber-optic SFP Module LC Connector
SFP Module Ports
The switch uses SFP modules for fiber-optic uplink ports.
5
8476
ATTENTION
Invisible laser radiation may be emitted from disconnected
fibers or connectors. Do not stare into beams or view directly
with optical instruments.
ATTENTION
Invisible laser radiation may be emitted from disconnected
fibers or connectors. Do not stare into beams or view directly
with optical instruments.