Switch User Manual
Table Of Contents
- 1783-UM002C-EN-E, Stratix 8000 Ethernet Managed Switches Hardware User Manual
- Preface
- Table of Contents
- 1 - Start
- 2 - Install the Switch
- Installation Guidelines
- Before You Begin
- Verify Package Contents
- Add Modules to the Switch
- Install the Switch
- Install or Remove the CompactFlash Card
- Set Up the Switch Initially with Express Setup
- Configure and Manage the Switch
- Reset the Switch to Factory Defaults
- Connect to the Switch Ports
- Verify Port Connectivity
- Verify Switch Operation
- Connect a Computer or a Terminal to the Console Port
- Run a Power-on Self-test (POST)
- Verify POST Results
- Disconnect Power
- Install and Remove SFP Modules
- Connect to SFP Modules
- 3 - Troubleshoot the Switch
- 4 - Cable and Connectors
- Index
- Back Cover
50 Publication 1783-UM002C-EN-P - April 2009
Chapter 2
6. While the Setup status indicator flashes green, start an Internet browser
session on the personal computer.
The switch prompts you for the default switch username and password.
7. Leave the username field blank.
8. Enter the default switch password, switch.
The Express Setup dialog box automatically appears.
9. If the window does not appear, do the following:
• enter the URL of a well-known website in your browser to be sure the
browser is working correctly.
Your browser will then automatically be directed to the Express Setup
web page.
• verify that any proxy settings or pop-up blockers are disabled on your
browser.
• verify that any wireless interface is disabled on your personal computer. .
TIP
You may also enter the URL
http://169.254.0.1/express-setup.htm
to access the Express
Setup page directly.