Switch User Manual
Table Of Contents
- 1783-UM002C-EN-E, Stratix 8000 Ethernet Managed Switches Hardware User Manual
- Preface
- Table of Contents
- 1 - Start
- 2 - Install the Switch
- Installation Guidelines
- Before You Begin
- Verify Package Contents
- Add Modules to the Switch
- Install the Switch
- Install or Remove the CompactFlash Card
- Set Up the Switch Initially with Express Setup
- Configure and Manage the Switch
- Reset the Switch to Factory Defaults
- Connect to the Switch Ports
- Verify Port Connectivity
- Verify Switch Operation
- Connect a Computer or a Terminal to the Console Port
- Run a Power-on Self-test (POST)
- Verify POST Results
- Disconnect Power
- Install and Remove SFP Modules
- Connect to SFP Modules
- 3 - Troubleshoot the Switch
- 4 - Cable and Connectors
- Index
- Back Cover
Publication 1783-UM002C-EN-P - April 2009 27
Chapter 2
The following table lists some port combinations using switch and expansion
modules.
The following figure displays example combinations of the 1783-MS06T
switch and expansion modules. The same combinations of expansion modules
can be used with a 1783-MS10T switch.
Switch and Expansion Module Port Combinations
Port Type Switch and Expansion Modules Combination
100FE
(copper)
100FX
(fiber optic)
4 one 1783-MS06T switch
8 one 1783-MS10T switch
4 8 one 1783-MS06T switch
one 1783-MX08F expansion module
12 one 1783-MS06T switch
one 1783-MX08T expansion module
8 8 one 1783-MS10T switch
one 1783-MX08F expansion module
16 one 1783-MS10T switch
one 1783-MX08T expansion module
12 8 one 1783-MS06T switch
one 1783-MX08T expansion module
one 1783-MX08F expansion module
20 one 1783-MS06T switch
two 1783-MX08T expansion modules
16 8 one 1783-MS10T switch
one 1783-MX08T expansion module
one 1783-MX08F expansion module
24 one 1783-MS10T switch
two 1783-MX08T expansion modules