User Guide User Manual

7-10
WebPak 3000 OIM User Guide
The clock is primarily used to show when a fault or alarm occurred. It is reset by
cycling power or by using the procedure described here.
To reset the clock:
Step 1. Press
until the key indicator reads
PROGRAM
.
Step 2. Press or until the cursor ( ) is pointing to Operator Interface.
Press
.
Step 3. Press or until the cursor is pointing to Reset Clock. Press .
Step 4. The
OIM
resets the elapsed time clock to 000 days 00 hours 00 mins 00 secs
and displays the message shown in figure 7.9. Press to return to the
menu.
Figure 7.9 – Reset Clock Message Screen