User Manual

13-4
WebPak 3000 DC Drive Application Workbook, Version 1.1
13.6 Armature Voltage Feedback
Use the following parameters if necessary to configure the armature voltage feedback.
Refer to figure A.10 in the software manual (D2-3444).
13.7 Underwind Operation
Unwind and winder applications can require “over-under operation,” which is simply a
way to implement reversing operation as different products are used.
•
Digital input at terminal 6 of the Regulator board initiates underwind mode.
•
UNDERWIND COMMAND
(P.877) indicates the state of the underwind enable command.
•
ARM VOLTAGE GAIN ADJ
(P.204)
P.204 =
•
ARM VOLTAGE ZERO ADJ
(P.205)
P.205 =