Manual

Configuring a Scanner

4-7

4.2.2 Mapping the Output I/O

Step 1. In the Datatable Map dialog box (see figure 4.11), select Output to map the

Output data. A dot appears in the circle.

Step 2. In the Map Data From box, select from where the data is transmitted.

Step 3. In the Map Data To box, select the destination of the data.

Step 4. In the O:1 box, type the word where the data will be found.

Step 5. In the Bit box, type the bit at which the data starts.

Step 6. In the No. Bits box, type the number of bits that your data requires.

Step 7. Click Apply Segment. A new datatable map appears in the dialog box.

Figure 4.12 – Output Datatable Map

Figure 4.13 – Output Datatable Map

