User Manual

8 TL-Series Servo Motors
Publication TL-IN003A-EN-P — June 2007
Shaft Seals
You may install the optional shaft seal to protect the front bearing from fluids or fine dust that could
contaminat e t he motor bearing and reduce its lifetime. The IP rating for the motor depends on the
usage of shaft seals.
Refer to these sections for additional information:
• Shaft Seal Kits on page 23 lists catalog numbers of seal kits available for your motor.
• Specifications on page 22 briefly describes IP ratings.
Install the TL-Series Motor
Before installing the motor, review and become familiar with the following instructions:
• Requirements for Motor Mounting
• Power Cable Shielding
• Installing the Motor
• Dimensions
• Motor Load Force Ratings
• Connector Dat a
Requirements for Motor Mounting
All TL-Series motors include a mounting pilot for a ligning the motor on a machine. Preferred
fasteners are stainless steel. The installation must comply with all local regulations and use of
equipment and installation practices that promote electromagnetic compatibility an d safety.
ATTENTION
Unmounted motors, disconnected mechanical couplings, loose shaft keys, and
disconne ct ed cables are danger ous if power is applied.
Disassembled equipment should be appropriately ident ified (t agged-out) and
have access to ele ct ri cal power restricted (locked- out).
Before applying power to the motor , remove the shaft key and other mechanical
couplings that could be thrown from th e shaf t .
Failure to observe these safet y pr ocedures cou ld result in persona l injury.