User Manual

TL-Series Servo Motors 23
Publication TL-IN003A-EN-P — June 2007
Accessories
Accessories available from the fac t ory include the following items.
Motor Cables
Factory m anufactured feedback and power cables are available in standard cable lengths. Transition
cables are available to allow connec ti on of servo motors with TLY catalog numbers to existing
N-Series power, feedback, and brake cables. Factory cables provide proper shield termination, which
reduces the potential for EMI.
F or a complete listing of available cables refer to your drive’s installation manual, contact your nearest
Rock well Automation sa les office, or access the inform ation from the website reference s in
Additional Resou r ces on pag e 24.
Connector Kits
Each connector kit includes the appro priate connector housing, pins, and backshell.
Shaft Sea l K its
Catalog numbers and dimensions for shaft seals are shown below.
Transition Cables
Transition cables interface between N-Series motor cables and the cables on servo motors with TLY
catalog numbers wi th increm ental encoders. T he cables are 500 mm (20.0 in.) in length.
Connector Kit Catalog Number Connector Kit Catalog Number
Feedback Connector 2090-KFBM6-00AA Power Connector 2090-KPBM6-16AA
Motor
Catalog
Number
(1)
(1)
Shaft seals require a lubricant to reduce wear. Lubricant is provided with kit.
Inside Diameter Outside Diameter Width
mm (in.) mm (in.) mm (in.)
TLY-A110, TLY-A120, TLY-A130 TL-SSN-1 8.9 (0.35) 16 (0.71) 3 (0.12)
TLY-A220, TLY-A230 TL-SSN-2 14.0 (0.55) 24 (0.95) 5 (0.20)
TLY-A2530, TLY-A2540, TLY-A310 TL-SSN-3 19.8 (0.78) 30 (1.18) 5 (0.20)
Feedback Cable
Catalog Num ber
Power and Brake Cable
Catalog Number
Power Only Cable
Catalog Number
2090-CFBM6CN-04AA 2090-CPBM6CN-16AA 2090-CPWM6CN-16AA