Instruction Manual

ManualsBrandsRockwell Automation ManualsEquipmentT8xxx Application Note Trusted System Mechanical Build

Trusted

AN-T80003

Issue 1 Feb 07 AN-T80003 1

Application Note

Trusted

System Mechanical Build

This application note explains the mechanical fitting of the Trusted

chassis and accessories into a

19” rack. This includes mounting details for:

T8100 Processor Chassis

T8300 Expander Chassis

T8270 Fan Tray Rack Mounted

T824x Power Shelves

T8292 MCB Power Distribution Unit

T8290/T8297 Output Power Distribution Unit

Issue Record

Issue

Number

Date Revised by Technical

Check

Authorised by Modification

1 Feb 07 Nick Owens Ray Brown Pete Stock Initial Issue

Summary of content (6 pages)

PAGE 1
TrustedTM AN-T80003 Application Note TrustedTM System Mechanical Build TM This application note explains the mechanical fitting of the Trusted 19” rack.
PAGE 2
TrustedTM AN-T80003 TrustedTM System Mechanical Build Mechanical Assembly TM The following steps defines a recommended procedure for fitting Trusted into a 19” rack. chassis and accessories TM 1. Mount the Trusted Power Supply (T8240) into the swingframe as required. The T8240 Power Shelves require T8247 support brackets to be fitted first and secured by fitting the first power shelf with M5 x 12 Pan Head Taptite screws and large plain and crinkle washers through the support brackets.
PAGE 3
TrustedTM AN-T80003 TrustedTM System Mechanical Build 4. Fit 5-off 60mm trunking brackets to the pivot side of the swingframe. Fixings are M5 x 8 Pan Head Taptite screws with large plain and crinkle washers. 5. Fit 60W x 40H x 1775mm long trunking to the brackets fitted above. Locate the trunking as close to the front of the swingframe as possible. Fixings are M5 x 8 Pan Head Taptite screws with large plain and crinkle washers. This trunking will be used for the power supply chassis incoming feeders. 6.
PAGE 4
TrustedTM AN-T80003 TrustedTM System Mechanical Build Completed Assembly The picture below shows a part assembled swingframe with three system chassis, three fan trays, trunking and rails fitted to brackets, MCBs for power distribution and T8290 power distribution units.
PAGE 5
TrustedTM AN-T80003 TrustedTM System Mechanical Build I/O Connectors The I/O connectors to the chassis backplane are DIN 41612 type connectors, and are mounted in TM either a single or a double connector hood. The double connector hood enables Trusted I/O Interfaces (of the same type) to be installed in a Companion Slot configuration in adjacent slots. To install an I/O connector in the chassis backplane: 1. Ensure the correct connector and chassis backplane slot are selected 2.
PAGE 6
ICS Triplex technologies and services are available worldwide. Regional Headquarters: Americas: 4325 West Sam Houston Parkway North, Suite 100 Houston Texas 77043-1219 USA Tel: +1 713 353 2400 Fax: +1 713 353 2401 Europe, ME & Africa: Hall Road Maldon Essex CM9 4LA UK Tel: +44 1621 854444 Fax: +44 1621 851531 Asia Pacific: Unit 2/12 Keegan Street O’Connor Western Australia Tel: +61 89 314 7787 Fax: +61 89 314 7786 www.icstriplex.com For technical support email: support@icstriplex.