Assembly User Manual

I/O Power Supply Assembly (T8060,T8062)

Industrial Control Services

Power Fail

Reset

Monitor Connector: J13

Type:

72 pin Edge Connector, 0.125” centerline

Mfg.:

AMP

Mfg. P/N:

530844

Pin Out:

TBD

Configuration

Current Sharing

The modules are capable of current sharing by connecting their outputs

together in parallel. This can be done external to the chassis or by using a

shorting bar that mounts directly to the output terminals on the chassis

backplane. This allows separate gro

ups of modules from within a single

chassis to have their outputs configured as: Single, Dual or N+1. The

module uses a passive “droop” method of current sharing and will share to

within 25% of the rated load.

Regent Power Supply Load Units

When using the power supply system with Regent and Regent+Plus , power

supply loading is based on the number of I/O modules in the I/O chassis

and the load imposed by each I/O module. Load units for each I/O module

are shown in that module’s product description and spec

ification sheet

under the

Safetybus Power

heading. A set of three power supply modules

will provide the following load units:

Available Load Units (for a set of 3 power supplies)

Number of I/O Units (Chassis):

Load Unit Capacity:

78 74