Owner's manual

Analog Output Modules (T3470A)
6 Industrial Control Services
For high integrity applications requiring fail - safe or fault
tolerant analog outputs, guarded analog outputs should be
used.
Field Wiring
Field wiring terminal blocks on the I/O chassis are used to
connect an external 24 VDC power source and analog loads to
the module. The terminal blocks are located directly above
and below the slot where the module is installed. Each
terminal block consists of ten #6 wire clamp screw terminals
capable of holding two 12 AWG wires. Figure 4 shows the
proper field wiring connections for the analog output module.