Owner's manual

RTD Input Equipment (T3432)
PD - 6037 Mar - 06 19
RTD Terminations
RTD wiring is connected to the scre w terminals located at the
bottom of the termination panel as shown in Figure 16 . When
terminating RTD wiring, follow the recommendations listed
below.
1. Greater accuracy is maintained with a heavier gauge RTD
lead wire. Lead wire resistance should not exceed
20 Ohms.
2. All RTDs within a group of eight must be the same RTD
type (American or European) and use the same number of
leads (2, 3 or 4 - wire). 2 - wire and 4 - wire RTDs can be mixed
in the same group.
3. For unused RTD inpu ts, short the +SENSE, - SENSE, and
- FORCE terminals together.