Owner's manual

RTD Input Equipment

(T3432)

6037

Mar

Figure

. Mounting Dimensions for the RTD Termination Panel.

Termination Panel Cable

The termination panel cable connects a RTD input module to

a RTD multiplexer installed in the termination panel. It

carries power to the Mux and routes serial data to the input

module. One end of the cable has a male DB

9 nine

connector that plugs into one of three connectors on the

termination panel. The opposite end should be cut to the

desired length and wired to the I/O chassis terminal block

immediately above the RTD input module. Do not connect the

shield wire at this end. The six wires in the cable are

connected to the I/O slot terminals as shown in Figure