User manual

Publication 1783-UM003D-EN-E - December 2009 69
Chapter 3
Configure VLANs
Use the VLANs dialog box to create, modify, and delete VLANs. To display
this dialog box, choose Configure>VLANs from the Device Manager Web
interface menu.
TIP
The following settings will reset if power to the switch is lost. To
maintain these settings, connect the switch to a Network Time
Protocol (NTP) server by using the command-line interface.
Optional Settings
Setting Description
Host Name A name for the switch. The name can have up to 31 alphanumeric characters. The name cannot contain a ?, a
space, or a tab. The default is Switch.
We recommend entering either the name, the location, or the IP address of the switch to help identify the
switch during monitoring or troubleshooting.
System Date The date that the switch read from the network management station or that was manually set during the
initial setup. If you change the date, the change takes effect immediately after you click Submit.
System Time The time that the switch read from the network management station or that was manually set during the
initial setup. If you change the time, the change takes effect immediately after you click Submit.
Time Zone This is the time zone that the switch automatically read from the network management station or that was
manually set during the initial setup. If you change the time zone, the change takes effect immediately after
you click Submit.
Daylight Savings Time Automatically checked only when the selected time zone is in the U.S., Europe, or Australia. Unchecked for all
other time zones.