User manual

52 Publication 1783-UM003D-EN-E - December 2009
Chapter 2
You can configure static VLAN routing for the Stratix 8300 switch by using
the Device Manager Web interface. For more complex routing, use the
command-line interface. See the following manuals:
• For more information on these features and how to modify them, see
the Cisco IE3000 Switch Software Configuration Manual, available from
http://www.Cisco.com
.
• For information on using the command-line interface for more complex
routing, see the Cisco IE3000 Switch Command-Line Interface Manual,
available from http://www.Cisco.com
.
Alarms
The switch has two hardware alarm relay contacts on the switch front panel.
• Major alarm relay
When closed, the major alarm relay indicates a dual-mode power supply
or primary temperature alarm.
• Minor alarm relay
When closed, the minor alarm relay indicates these alarm states:
– Link fault
– Port not forwarding
– Port not operating
– FCS bit error rate
Cryptographic IOS
Software
A separate cryptographic version of the Stratix 8000 and Stratix 8300 IOS is
available for ordering from Rockwell Automation. The cryptographic version
supports Secure Shell (SSH) Protocol v2 and SNMPv3. This version provides
network security by encrypting administrator traffic during Telnet and SNMP
sessions. The distribution of the cryptographic IOS is controlled by U.S.
export regulations.
Refer to Upgrade the Switch Firmware on page 106
to install the
cryptographic IOS software.