User manual

44 Publication 1783-UM003D-EN-E - December 2009
Chapter 2
In the following figure, E1 or E2 should be configured as the primary edge
port.
REP Ring Segment
The segment shown in the following figure, with both edge ports located on
the same switch, is a ring segment. In this configuration, there is connectivity
between the edge ports through the segment. With this configuration, you can
create a redundant connection between any two switches in the segment.
In the following figure, E1 or E2 should be configured as the primary edge
port.
E2E1 E2E1
E1
Edge port
Blocked port
Link failure
201888
E2E1
201889