User manual

109Publication 1783-UM003D-EN-E - December 2009 109
Chapter 4
Manage the Switch via RSLogix 5000
Software
Introduction
After you complete Express Setup, you can manage the switch by using the
RSLogix 5000 software.
EtherNet/IP CIP Interface
Stratix 8000 and Stratix 8300 switches contain an EtherNet/IP network
interface. EtherNet/IP is an industrial automation network specification
maintained by the Open DeviceNet Vendor Association (ODVA). It uses the
Common Industrial Protocol (CIP) for its application layer, and
TCP/UDP/IP for its transport and network layers. This interface is accessible
via any of the switch's Ethernet ports by using the IP address of the switch.
Topic Page
EtherNet/IP CIP Interface 109
Add a Switch to the I/O Configuration Tree 114
Configure Module Properties 116
Connection Properties 119
General Switch Properties 120
Basic Port Properties 122
Advanced Port Properties 124
Port Thresholds (Storm Control) 128
Save and Restore Switch Configuration 130
Monitor and Reset the Switch 131
Switch Status 133
Port Status 135