User Manual Version 1.0 Owner manual

7-4 SP600 AC Drive User Manual
24 Digital Out 2 – N.O.
1
Run See description at No.s 11-13. 380 -
387
25 Digital Out 2 Common
26 Digital Out 2 – N.C.
1
NOT Run
1
Contacts shown in unpowered state. Any relay programmed as Fault or Alarm will energize (pick up)
when power is applied to drive and deenergize (drop out) when fault or alarm exists. Relays selected for
other functions will energize only when that condition exists and will deenergize when condition is
removed.
2
These inputs/outputs are dependent on a number of parameters. See “Related Parameters.”
3
Differential Isolation - External source must be less than 10V with respect to PE.
4
Differential Isolation - External source must be maintained at less than 160V with respect to PE. Input
provides high common mode immunity.
Table 7.1 – Wiring Signal and Control I/O to the Terminal Block (Continued)
No. Signal
Factory
Default Description
Related
Param.
14
26
13
1