User Manual Version 1.0 Owner manual

6-2 SP600 AC Drive User Manual
Replacing the Cover
Follow these steps to replace the drive cover on NEMA 1 drives:
Step 1. Place the cover straight on the drive to avoid damaging
the connector pins.
Step 2. Tighten the cover screw.
6.1.2 Removing and Replacing the Cover on NEMA
4x/12 Drives
Removing the Cover
Follow these steps to remove the drive cover on NEMA 4x/12
drives:
Step 1. Remove any user-supplied locks from the drive.
Step 2. Loosen the four cover screws (refer to figure 6.2). Frame
E has a total of 10 screws that need to be loosened.
Step 3. Lift the cover straight off the drive to avoid damaging the
connector pins.
Figure 6.1 – Removing the Drive Cover (NEMA 1 Drives)
Front View
Bottom View