User Manual Version 1.0 Owner manual

About the Drive 2-23
2.7 Drive Communication Options
The flat-ribbon cable connector (labeled in figure 2.4 and in
figure 2.5) is a parallel bus connection port that provides a means of
attaching optional communication modules such as the DeviceNet
Network Communication module to the SP600 AC drive.
The optional module is mounted inside the drive. Refer to the
appropriate module instruction manual for more information. See
2.7 for a list of available communication options.
2.8 Remote Operator Interface
The SP600 drive can be controlled and monitored using a remote
LCD OIM (Operator Interface Module). Note that you must set
parameters 89 and 90 to “DPI Port 2” to enable control from the
remote keypad.
2.8.1 Connecting the Remote OIM or VS Utilities to
the Drive
NEMA 1 Drives
The remote OIM or VS Utilities (via the Serial Converter, see
section 2.10) connects to DPI port 2 at the bottom of the drive frame
(labeled in figure 2.4).
Table 2.7 – Communication Options Model Numbers and Instruction Manual Numbers
Description Model Number
Instruction
Manual
DeviceNet Communication Module RECOMM-DNET D2-3478
Profibus Communication Module RECOMM-PBUS D2-3479
Interbus Communication Module RECOMM-IBUS D2-3480
ControlNet Communication Module RECOMM-CNET D2-3497
EtherNet/IP Communication Module RECOMM-ENET D2-3510
RS485 DF1 Communication Module RECOMM-485 D2-3514
Table 2.8 – Remote OIM Model Numbers and Instruction Manual Numbers
Description Model Number
Instruction
Manual
Remote NEMA 4X LCD OIM RE4LCD-PNL D2-3490
Remote Small NEMA 4X LCD OIM RE4ALCD D2-3525