Installation and Operation Manual Owner manual

Wiring the Drive 5-5
Start and Stop Control Wiring
Start and stop control wiring connects to terminals 6, 7, and 11. See figures 5.5 and
5.6. Note that these start/stop wiring connections are not to be used in multi-speed
preset applications which are discussed in the following section.
Figure 5.5 – Two-Wire Start/Stop Sample Control Wiring
Figure 5.6 – Three-Wire Start/Stop Sample Control Wiring
Start/
Stop
IET
Reset
Fwd
Rev
Function
Loss
Customer
Interlock
Stop
Start
IET Reset
Forward/Reverse
Function Loss
24 VDC Common
Stop
IET
Reset
Fwd
Rev
Function
Loss
Customer
Interlock
Start
Stop
Start
IET Reset
Forward/Reverse
Function Loss
24 VDC Common