Installation and Operation Manual Owner manual
Compliance with Electromagnetic Compatibility Standards
E-5
• When the drive is connected to three-phase AC input power, the three output leads
from the filter should be connected to the drive’s AC input power terminals as shown
in figure E.3.
• Connect the filter ground wire (green/yellow) to the drive ground.
.
Figure E.2 - Typical SP500 Single-Phase Connections
Figure E.3 - Typical SP500 Three-Phase Connections
RS TGND
UV WGND
SP500
L L L E(GND)
REDYELLOW BLUE YELLOW
AC MAINS FILTER
GREEN/
AB
12 3
MOTOR
FILTER’S AC INPUT POWER
DRIVE’S AC INPUT POWER
RS TGND
UV WGND
SP500
L L L E(GND)
REDYELLOW BLUE YELLOW
AC MAINS FILTER
GREEN/
AB
12 3
MOTOR
C
FILTER’S AC INPUT POWER
DRIVE’S AC INPUT POWER