Manual

Editing Drive Parameters 7-11
P-23 Analog Input 1 Gain Model
A B C
When using analog input 1 for a
speed reference, use this parameter
to set the level of the analog input
used to command Maximum Speed
(P-01).
Parameter Range: 0.0 to 110.0 (x.x%) X X
Default Setting: 100.0 X X
Running Access: RW
P-24 Analog Input 2 Offset Model
A B C
When using analog input 2 for a
speed reference, use this parameter
to set the level of the analog input
used to command Minimum Speed
(P-00).
Parameter Range: 0.0 to 110.0 (x.x%) X
Default Setting: 0.0 X
Running Access: RW
P-25 Analog Input 2 Gain Model
A B C
When using analog input 2 for a
speed reference, use this parameter
to set the level of the analog input
used to command Maximum Speed
(P-01).
Parameter Range: 0.0 to 110.0 (x.x%) X
Default Setting: 100.0 X
Running Access: RW
P-26 Process Proportional Gain Model
A B C
Use this parameter to specify the
proportional gain (Ki) for the closed
loop process PI controller. It is used
only when P-29 (Process Operation)
is set to 2 or 3 to select PI control or
Parameter Range: 0 to 10.0 (x.x decimal) X
Default Setting: 0 X
Running Access: RW
inverted PI control. This parameter is scaled so that when it is set to 1.0, the process response is 1 Hz when
the process error is 1 Hz. The correct value for this parameter depends on the dynamics of the process being
controlled, as well as the desired response.