Manual

Contents

CONTENTS AND

INSTALLATION CHECKLIST

❏ Chapter 1 Identify Your Drive.................................................................................................. 1-1

❏ Chapter 2 Install the Drive....................................................................................................... 2-1

❏ Chapter 3 Install External Components ................................................................................. 3-1

3.1 Install Branch Circuit Protection ...................................................................... 3-1

3.2 Install an AC Input Disconnect ........................................................................ 3-2

3.3 Install Motor Overload Protection .................................................................... 3-2

❏ Chapter 4 Wire Input Power and Output Power .................................................................... 4-1

4.1 Wire AC Power to the Drive and Motor ........................................................... 4-2

❏ Chapter 5 Wire the Control Signal Terminal Block ............................................................... 5-1

5.1 Install an Emergency Stop............................................................................... 5-3

Chapter 6 Using the Local Keypad......................................................................................... 6-1

6.1 Display Description.......................................................................................... 6-2

6.2 Run and Program LED Descriptions ............................................................... 6-2

6.3 Step-by-Step Keypad Operation...................................................................... 6-3

❏ Chapter 7 Editing Drive Parameters....................................................................................... 7-1

7.1 Program Parameters ....................................................................................... 7-2

7.1.1 Protection Parameters (Group 0) .......................................................... 7-2

7.1.2 Digital Input/Output Control Parameters (Group 1).............................. 7-4

7.1.3 Speed Reference Parameters (Group 2) .............................................. 7-7

7.1.3.1 Selecting the Speed Reference for Model A and

Model B Drives........................................................................ 7-7

7.1.3.2 Selecting the Speed Reference for Model C Drives ............... 7-9

7.1.3.3 Speed Selection Examples ..................................................... 7-9

7.1.4 Dynamic Control Parameters (Group 3).............................................. 7-13

7.1.5 Fixed Speed Parameters (Group 4) .................................................... 7-15

7.1.6 V/Hz Curve Parameters (Group 5)..................................................... 7-17

7.1.7 Utility Parameters (Group 6)................................................................ 7-19

7.2 Display Parameters ....................................................................................... 7-21

❏ Chapter 8 Check the Installation............................................................................................. 8-1

8.1 Check the Installation with the Power Off........................................................ 8-1

8.2 Check the Direction of Motor Rotation............................................................. 8-2

8.3 Test the Drive under Load ............................................................................... 8-2

❏ Chapter 9 Diagnostics and Troubleshooting......................................................................... 9-1

9.1 Problems Not Reported by Fault Codes.......................................................... 9-1

9.2 Problems Reported by Fault Codes ................................................................ 9-2