Manual

Editing Drive Parameters 7-1
CHAPTER 7
Editing Drive Parameters
The SP200 drive has two types of parameters: program parameters (P-xx), which
configure the drive operation, and display parameters (d-xx), which display information
regarding the drive status. Sections 7.1 and 7.2 provide descriptions of all drive
parameters. The table below shows the parameter organization.
Important: The default value of most parameters is appropriate for most applications.
The following parameters may need to be adjusted for some applications.
Table 7.1 – Parameter Organization
Range Parameter Group Parameter Type
P-00 to P-05
P-10 to P-13
P-20 to P-29
P-30 to P-38
P-40 to P-48
P-50 to P-55
P-60 to P-64
Protection
Digital Input/Output
Speed Reference
Dynamic Control
Fixed Speeds
V/Hz Curve
Utility
Program Parameters
d-00 to d-09 Display Parameters Display Parameters
• P-00 Minimum Speed • P-30 Acceleration Time 1
• P-01 Maximum Speed • P-31 Deceleration Time 1
• P-02 Motor Overload Current • P-34 Stop Control
• P-03 Reverse Disable • P-40 Internal / Jog Frequency
• P-10 Start Control • P-50 Base Voltage
• P-20 Main Speed Reference • P-51 Base Frequency