User Manual

Programming Basics
3-3
Note the following when using the keypad:
• If you were viewing a display (
d
) parameter when power
was last removed from the drive, the same display
parameter value will reappear when the drive is
re-powered.
If you were viewing any other parameter value (
A, b,
or
C
)
when power was removed, the parameter group or
parameter number will appear when the drive is
re-powered.
• When viewing parameters within the
A
,
b,
and
C
groups,
the parameters will wrap from A01 through C91 by
pressing
▲
or
▼
. To view parameters within the
d
and
F
groups, press PROGram until the display shows
A - -
,
b - -
or
C- -
. Once the group letter is displayed, use
▲
or
▼
to
scroll to the
d
and
F
parameters.
Table 3.1 – Key Descriptions
Key Description
• Toggles between parameter number and
parameter value.
• Selects the parameter group or individual
parameter.
• Scrolls through parameters or parameter groups.
• Increases or decreases parameter values.
Enters the displayed value into memory.
When the Start key is active, starts the motor in the
direction of rotation defined in F04 [
START KEY
DIRECTION
].
• Stops the motor.
• Clears drive faults.
PROG