Instruction Manual

4-2
Using the SP200 AC Drive Demo Unit
Step 3. Press or until P-60 [
RESET TO DEFAULTS
] is
displayed.
Step 4. Press
to display the value of P-60 (0 should be
displayed).
Step 5. Press to change the value to 1(Reset All Values
to Factory Defaults).
Step 6. Press to accept the value.
The drive’s factory defaults have been restored.
Lab 1b: Setting up a basic drive configuration that uses
external I/O control.
Step 1. Press until the
PROGRAM LED
turns on to enter
program mode.
Step 2. Press or until P-00 [
MINIMUM SPEED
] is
displayed.
Step 3. Press to display the value of P-00.
Step 4. Press or until the value 5 is displayed. This
sets the minimum speed to 5 Hz.
Step 5. Press to accept the value.
Step 6. Press until P-01 [
MAXIMUM SPEED
] is displayed.
Step 7. Press
to display the value of P-01.
Step 8. Press or to change the value to 60, if
necessary.
Step 9. Press to accept the displayed value.
Step 10. Repeat this process for all of the parameters listed
in table 4.2. The parameter settings are based on
the demo unit’s motor nameplate data listed below.
Note that the demo un it contains a Mode l C S P200 drive.
• 1600 RPM
• .22 A FLA
• 60 Hz
PROG