Specifications

Index
I–7
Publication 1747-6.2
output circuit operation, 10-28
output contact protection, selecting, 2-26
output modules
features, 7-6
installing, 6-2
troubleshooting, 10-28
wiring, 7-7
Overview of the Modular Control System
Principles of Machine Control, 2-3
system overview , 2-2
system test general specifications, 2-8
P
PanelV iew 550 Operator T erminal,
monitoring with, 2-17
parts, replacement, 1 1-1
performance, Ethernet processor, G-2
pinout, channel 0, B-2
planning considerations for a network, A-7
Power Considerations
Common Power Source, 3-8
Input States on Power Down, 3-10
line conditions, other types of, 3-10
Loss of Power Source, 3-10
power source, loss of, 3-10
power supplies
installing, 6-8
selecting, 2-1
1
setting jumpers, 6-8
specifications
24V dc user power output current,
2-11
24V dc user power output voltage,
2-11
ambient operating temperature rating,
2-11
certification, 2-1 1
fuse protection, 2-1 1
humidity rating, 2-1 1
internal current capacity , 2-1 1
line voltage, 2-1 1
maximum inrush current, 2-1 1
storage temperature, 2-1 1
typical line power requirement, 2-1 1
wiring, 2-1 1
power supply fuse, replacing, 9-8
power supply loading at 5V dc, processor
specification, 2-9
Power Supply W orksheet, E-1
power , removing, 10-2
Preparing Your Wiring Layout, 7-4
Preventing Excessive Heat, 3-3
Preventive Maintenance, 3-12
processor
initial factory conditions
baud rate, 8-3
channel 0 configuration, 8-3
I/O slot enables, 8-3
mode, 8-3
node address, 8-3
processor name, 8-3
watchdog values, 8-3
installation, 6-1
processor hardware features
SLC 5/01, 5-2
SLC 5/02, 5-4
SLC 5/03, 5-6
SLC 5/04, 5-9
SLC 5/05, 5-12, 5-13
processor specifications
ambient temperature rating, 2-9
bit execution, 2-9
certification, 2-9
humidity , 2-9
LED indicators, 2-9
local I/O capacity
, 2-9
maximum chassis/slots, 2-9
memory back-up options, 2-9
noise immunity , 2-9
power supply loading at 5V dc, 2-9
program memory , 2-9
program scan hold-up time after loss of
power , 2-9
remote I/O capacity , 2-9
scan time, typical, 2-9
shock (operating), 2-9
standard RAM, 2-9
vibration, 2-9
PROG, keyswitch position for the SLC 5/03
and SLC 5/04 processors, 5-15
program alteration, 10-3
program memory , processor specification,
2-9
program scan hold-up time after loss of
power , 2-9
Programmable Controller Grounding and
Wiring Guidelines, 3-4
publications, related, P-3
pulses, transient, 2-27