Owner's manual

Installation
3-1
C
HAPTER
3
Installation
This chapter describes how to install and replace the UDC module. Refer to the
appropriate Distributed Power System Diagnostics, Troubleshooting, and Start-Up
Guidelines instruction manual for system connection instructions.
3.1 Wiring
The installation of wiring should conform to all applicable codes. To reduce the
possibility of noise interfering with the control system, exercise care when installing
wiring from the system to external devices. For detailed recommendations, refer to
IEEE Standard 518.
3.2 Initial Installation
Use the following procedure to install the module:
Step 1. Stop any application tasks that may be running.
Step 2. Turn off power to the system. All power to the rack, as well as all power to the
wiring leading to the rack, should be off.
Step 3. Take the module out of its shipping container. Take it out of its anti-static bag,
being careful not to touch the connector on the back of the module. Save the
anti-static bag in a safe place. The module must be stored in an anti-static
bag whenever it is not installed in the rack.
!
!