,Startup,Guide User Manual

AutoMax Programming Executive Access Levels H-1
APPENDIX H
AutoMax Programming
Executive Access Levels
Rack Power Supply Keyswitch Position
Any
Position PROTECT SETUP PROGRAM
User’s Access Level
Action None
Any
Level Data Task Rack Data Task Rack
Force Common No No No No No Yes Yes Yes
Force Local No No No No No No Yes Yes
Force I/O No No No No No Yes Yes Yes
Set Common No No No No No Yes Yes Yes
Set Local No No No No No No Yes Yes
Set I/O No No No No No Yes Yes Yes
Set/Tune Tunable No No No Yes Yes No Yes Yes
Load Normal Config No No No No No No No Yes
Load Debug Config No No No No No No No Yes
Load Single POB File No No No No No No
Yes
1
1. Must have Task access to both tasks in the UDC
Yes
Load Single Task No No No No No
No
2
2. A single task may be loaded with only Data access if the task does not already exist on the AutoMax Processor or UDC module.
Yes Yes
Delete Task No No No No No No Yes Yes
Start Task No No No No No No Yes Yes
Stop Non-Critical Task No No No No No No Yes Yes
Save Task from Rack No
Yes
3
3. Requires Task or Rack access.
No Yes Yes No Yes Yes
Load All POB Files No No No No No Yes Yes Yes
Load All No No No No No No No Yes
Delete All Tasks No No No No No No
Yes
4
4. Must have Task access to all tasks.
Yes
Start All Tasks No No No No No No
Yes
4
Yes
Stop All Tasks No No No No No No
Yes
4
Yes
Load AutoMax OS No No No No No No No Yes
Load Single UDC OS No No No No No No
Yes
1
Yes
Load All UDC OS No No No No No No
Yes
1
Yes
Modify PC Task No No No No No No Yes Yes
Auto Run No No No No No Yes Yes Yes
Monitor Yes Yes Yes Yes Yes Yes Yes Yes
Note that a user with privileged (Data, Task, or Rack) access may relinquish this privilege by timing out after two minutes off-line, or by
selecting to relinquish access on-line. Functions not listed in the table do not require privileged access.